1 / 7
Battery case 18650 with room for charger and step-up converter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A battery case for 18650 Lipos with room for a perfboard 80x20 mm (e.g. to house both a charge circuit and a step-up…
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 50
- Makes
- 0
- Views
- 547
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
A battery case for 18650 Lipos with room for a perfboard 80x20 mm (e.g. to house both a charge circuit and a step-up converter). Cutout for a 12x19 mm switch to separate the (+) output of the charger/protector from the input of the step-up converter.
Parts used:
- Perfboard 80x20 mm
- USB LiPo Charger/Protector TP 4056 (board version with integrated output overload/undervoltage cutoff)
- Step-Up Converter MT 3608.
- On/Off switch snap-in for cutout 19x12 mm, 250V / 3A, height beneath front panel 19mm.
Assembly:
- both boards soldered with 0,7 wire as stand-off onto the perfboard.
- use the battery terminals of the TP4056 board as contact points
- use some loops of uncoated copper wire around the plastic springs for the battery terminals.
- use isolated wire to connect the loops to the battery terminals of the TP4056
- connect ground/minus directly between TP4056 output pad and MT3608 input pad
- connect plus through the on-off switch. Can be made with 6.35 mm crimp connectors if you cut off the crimp part and solder the wires along the cut line.
Print Settings
Printer:
TronXY X5S
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.6 mm nozzle, 0.25 mm layer height
Infill:
15%
Filament:
Generic budget PLA
gray transparent
Category: Electronics