(Early Release) 1/7 Scale FS&S 500-SHTT
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 1/7 scale model of the Federal Sign & Signal 500-SHTT siren! It rotates and makes noise, just like the real thing.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 119
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This siren has a 3 inch rotor, so it's not all that loud, but it does function!
This model is functional with parts printed on an Ender-3 Max Neo, but I'm not sure about the fancier CoreXY printers.
This is an early release model. Proper building instructions and possibly a few revisions will come soon.
You'll need to buy this or a similar 370 motor, this set of slip rings, these or similar 2mm shaft couplers, and two 695 bearings. This uses two of the shaft couplers, and you'll need to combine the wires on the slip rings for the motor. The slip ring flange goes inside the upper baseblock and is secured with three M3x5 screws. You also need a small rubber band of sorts for the pulleys.
Screws needed:
29 M2x4
9 countersunk M2x4
9 countersunk M2x6
20 M2.5x4
6 M2.5x6
8 countersunk M2.5x6
4 M2.5x8
3 M3x5
You could assemble the whole thing with this screw kit and have a lot of screws left over for other things.