Rugged Case for 12× BETAFPV LAVA II 1S 580mAh Batteries
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A compact and rugged storage case designed specifically for 12 LAVA II 1S 580mAh LiHV batteries with BT2.0 connectors
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Rugged Case for 12× BETAFPV LAVA II 1S 580mAh Batteries
A compact and rugged storage case designed specifically for 12 BETAFPV LAVA II 1S 580mAh LiHV batteries with BT2.0 connectors.
The batteries are stored vertically in individual slots arranged in a 3×4 layout. This keeps them organized, prevents them from moving around inside the case and leaves the connectors easily accessible.
Features
Holds 12 BETAFPV LAVA II 1S 580mAh batteries
Individual slot for every battery
Compact 3×4 arrangement
BT2.0 connectors remain accessible
Reinforced rugged-style body
Hinged lid with a centered front latch
Suitable for storage and carrying batteries to indoor or outdoor FPV sessions
Approximate external dimensions: 68.5 × 92.9 × 84.8 mm
Compatibility
The case was designed and test-fitted with:
BETAFPV LAVA II 1S 580mAh 3.8V LiHV batteries with BT2.0 connectors
Other batteries may fit, but compatibility has not been tested.
Printing
PETG is recommended for better impact resistance and improved temperature resistance during transport. PLA should also work for normal indoor use.
For a durable functional print, use at least:
0.20 mm layer height
3 perimeters
0% infill - just add modifier on first 1.6mm to keep gyroid infill at 15%, the rest can eaisly go with 0% to save time and material, just set bridge speed at 10mm/s and should work well.
Required hardware
2× M3×35 mm headless set screws or metal pins for the front latch
1× M3×45 mm headless set screw or metal pin for the rear hinge
Depending on the printer tolerances, the M3×45 mm hinge pin may need to be shortened to approximately 43 mm. Smooth 3 mm metal rods cut to the required length can also be used.