Support for Framework Laptop 12 Motherboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This model uses generated supports to hold the laptop motherboard.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model that holds your Motherboard at a 20 degree angle to the right and a 10 degree angle forward (shown in pictures 6 and 7). It uses little time printing in under 45 minutes and uses little filament.
To print the supports right follow all the setting changes here.
Enable support Yes; Obviously
Type Tree (manual); You can use auto, but it may generate supports on the side of the screw holder which will interfere with the seating of the board, so I recommend putting in the work to manually select all the pieces
Style Tree Hybrid; I found that Hybrid looked the best but use any you like
First layer density 100%
First layer expansion 0 mm
Top Z distance 0 mm
Support wall loops 2
Top interface spacing 0 mm
Bottom interface spacing 0 mm
Support/object XY distance 0 mm
After printing all the supports, put them in the screw holes with the top of the board facing up, either long side can be on the front, rotate the supports until you feel and see that the bottom is flat on the ground then screw them in place.