ExtrusionLengthGauge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This device shows the length of extruded filament for calibrating the extruder steps. The big wheel requires 200 mm of…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 60
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This device shows the length of extruded filament for calibrating the extruder steps. The big wheel requires 200 mm of 1.75 mm filament to run along the circumference for a full rotation. The small arrows are 10mm apart each, the long arrows mark 100 mm.
To calibrate the extrusion, thread the filament between the wheels, set a long arrow on the marker and send an "extrude 100 mm" command to the printer.
If the actual length falls short of the marker or overshoots, adjust the E steps accordingly, align the long arrow again and repeat until you're happy with the result.
The holes and mounting pins are meant for 608 type bearings (22 x 7 x 8 mm). Fixate them with short M4 screws and washers.
Print Settings
Printer:
TronXY X5S (2018)
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.6 mm nozzle, 0.3 mm layer height
Infill:
15% linear
Filament:
generic PLA
any Custom Section ==============
Category: 3D Printer Accessories