ExtrusionLengthGauge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This device shows the length of extruded filament for calibrating the extruder steps. The big wheel requires 200 mm of…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 60
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This device shows the length of extruded filament for calibrating the extruder steps. The big wheel requires 200 mm of 1.75 mm filament to run along the circumference for a full rotation. The small arrows are 10mm apart each, the long arrows mark 100 mm.
To calibrate the extrusion, thread the filament between the wheels, set a long arrow on the marker and send an "extrude 100 mm" command to the printer.
If the actual length falls short of the marker or overshoots, adjust the E steps accordingly, align the long arrow again and repeat until you're happy with the result.
The holes and mounting pins are meant for 608 type bearings (22 x 7 x 8 mm). Fixate them with short M4 screws and washers.
Print Settings
Printer:
TronXY X5S (2018)
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.6 mm nozzle, 0.3 mm layer height
Infill:
15% linear
Filament:
generic PLA
any Custom Section ==============
Category: 3D Printer Accessories