Modular Desk Shelf & Monitor Riser with 4 Drawers | Fusion 360 + Snapmaker 10W Laser Inlays
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A sleek, functional desktop shelf and monitor riser built around a 3D-printed modular chassis and laser-engraved details
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
A heavy-duty, functional workstation riser and desk organizer designed to lift a monitor, route cables, and stow everyday gear. Engineered in Autodesk Fusion (Personal/Hobby) and sliced/prepared in Snapmaker Luban.
The build features a rigid matte-black chassis paired with 4 high-contrast utility drawers and laser-engraved 2.5 mm card stock accents on the top and sides. Because the full chassis measures nearly 400 mm in width, it is split into two halves in Fusion to print flat and reliably on standard build volumes. The seam is seamlessly joined and concealed during post-processing.
Project Specifications & Print Parameters
Main Riser Body:
Machine: Snapmaker Artisan
Material: White PLA + Snapmaker Breakaway Support Filament (~1.1 kg total)
Nozzle Size: 0.6 mm
Layer Settings: 15% infill
Print Time: ~30 hours
Post-Processing & Seam Assembly:
Align and bond the two printed halves using CA glue or two-part epoxy along the mating split face.
Bridge and fill the center joint with automotive body putty/filler.
Sand flat with a Bosch random orbital sander (220-grit) across the entire joint and top/side surfaces.
Hand-finish with 320-grit wet/dry paper.
Alternate coats of spray-on high-build filler primer and fine sanding to completely erase the seam line.
Finish with a smooth matte black acrylic coat.
Modular Drawers (Set of 4):
Machine: Snapmaker A250
Material: Natural/raw filament colors (no paint needed; ~800 g total across all 4 units)
Nozzle Size: 0.4 mm
Layer Settings: 15% infill
Print Time: ~25 hours total
Laser Inlay Panels (Top & Sides):
Machine / Module: Snapmaker Artisan with 10W Diode Laser Module
Material: 2.5 mm heavy white card stock
Engrave Settings: Work speed 12,000 mm/min @ 25% Power
Cut Settings: Work speed 12,000 mm/min @ 100% Power
Assembly & Finishing Tips
Support Removal: Snapmaker support filament separates cleanly from the main bridging surfaces on the Artisan dual-extrusion module.
Smoothing: Apply thin coats of automotive putty to conceal seam and layer lines. Let cure completely before taking the orbital sander (220 grit) to the wide flat panels.
Face Inlays: The 2.5 mm engraved card stock pieces fit directly into the recessed side and top cavities using standard craft adhesive or thin double-sided tape.