30s1p 21700 Pint X battery box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
largest monolithic pack you can fit in the pint x platform
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
In the end it would've been easier to design from scratch but here's a 30s1p 21700 capable pint x battery box. Interior has been expanded to take advantage of negative space left both inside the box and inside the bumpers. Flat gasket for the lid reduces machining time and cost too.
Same things apply as with Cal's box, same hardware and only supports TFL bang bumpers. Threads are the same in the lid. Battery needs to be frameless to fit however, and I used a xlite-32, don't know if anything else would fit
Needs 2mm EVA foam for the lid, both as a gasket and battery support. Just cover entire underside of the lid like with the Torquebox 2 from tfl.
Gortex patch has been switched to a threaded breather, here's the one I used: https://a.co/d/0hnILvxr
It is possible to over-tighten the screws with the foam gasket, so be weary and just test fitment on rails before going too far; should be snug in the rails with no movement.
Box - minimum petg, preferably stronger material, make 100% walls, supports required
Lid - 6061 okay, be weary of thread strength if doing so, they will strip easily. 7075 preferred (cost me about $60 through JLC w/ 6061)