IKEA SAMLA 45L filament storage rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Storage rack for filament storage in IKEA SAMLA 45L bins.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Rack for IKEA 45L SAMLA bins.
Each rack fits 10 rolls of filament (e.g. Creality, Bambu or Prusa). My 123-3D rolls are just a bit too wide to fit 5 in a row.
For the full storage solution you'll need 4 pieces of 8mm dowels. (or similar 8mm rods, or you could even print some.)
Additionally I used some foam tape to make the SAMLA's airtight. https://www.amazon.nl/-/en/dp/B0D425PNZQ
The sensor holder fits these cheap hygrometers: https://www.amazon.nl/-/en/dp/B0DK4P9RDS
Note:
The model is inspired on this one on makerworld: https://makerworld.com/en/models/202698-tradforvara.
I thought that one looked a bit flimsy and don't like the clips as they are known to break. So I designed something from the ground up. Now it consists of 4 intersecting pieces and some wooden dowels (8mm).
(printables doesn't allow me to link to makerworld so I had to upload it as an original model)