1 / 5
60g High-Airflow Silica Gel Container for Filament Spools — zdjęcie 1
1 / 5

60g High-Airflow Silica Gel Container for Filament Spools

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

High-airflow silica gel container designed to fit inside the center of a filament spool.

Ocena
0 / 5
Polubienia
1
Pobrania
24
Wydruki
0
Wyświetlenia
86
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

60g High-Airflow Silica Gel Container for Filament Spools

Keep your filament dry while it is stored.

I designed this reusable desiccant container to fit inside the center of a filament spool and provide as much airflow around the silica gel as possible.

Instead of using only ventilation holes on the outside wall, the container allows air to reach the silica gel from multiple directions.

The body is highly perforated around its circumference, while both the bottom and screw-on lid are ventilated. A central perforated air channel also allows air to reach the silica gel deeper inside the container.

The result is a compact container with a measured capacity of approximately 59.6 g of silica gel.

Features

≈60 g measured silica gel capacity

Designed for the center of filament spools

High-airflow perforated body

Ventilated bottom

Ventilated screw-on lid

Central ventilation channel

Radial ventilation pattern

Reusable and refillable

Threaded lid

No supports required

Easy to print

Suitable for indicating/rechargeable silica gel beads

Helps keep filament dry during storage

Airflow design

The container uses several ventilation paths instead of relying only on holes in the outer wall.

Air can reach the silica gel through:

the perforated cylindrical wall

the radial holes in the bottom

the radial holes in the lid

the perforated central air channel

This increases the exposed area of the silica gel while keeping the beads securely inside the container.

Capacity

The prototype was filled and weighed with silica gel beads.

Measured silica gel capacity: 59.6 g

The exact capacity may vary slightly depending on the size and type of silica gel beads used.

Dimensions

Outer diameter: 50 mm

The container was designed to fit inside the center opening of common filament spools. Please measure the center hole of your spool before printing.

Print settings

The prototype shown in the photos was printed on a Prusa MK4S.

Printer: Prusa MK4S

Nozzle: 0.4 mm High Flow

Material: PLA

Layer height: 0.20 mm

Supports: No

Brim: Not required

PETG can also be used if you prefer a material with better temperature resistance.

Important note

If you regenerate silica gel using heat, remove the silica gel from the printed container first.

Do not place a PLA container in an oven used for regenerating silica gel.

Assembly and use

Fill the body with dry silica gel beads.

Do not overfill it — leave enough space for the lid to engage the thread easily.

Screw the lid on by hand and place the complete container inside the center of your filament spool.

When the indicating silica gel shows that it has absorbed moisture, open the container, remove the silica gel and regenerate or replace it.

Tagi