Filament Toaster Desiccant Holders

Desiccant holding boxes for the West3D Filament Toaster. The 35mm tall ones have enough clearance so that you don't need to remove them when you change spools, but the others are tall enough that you'll need to move them when inserting or removing spools.

The 55mm and 100mm tall ones are large enough that you can install a hygrometer, though it can be a little hard to read. I stack a 55mm hygro box on top of my 35mm ones and move it around as necessary.

Don't print in PLA: PETG at minimum is required, and something even more temperature resilient is necessary if using the toaster at high temperatures. ABS, ASA, or PC-CF work well.

At 100C+, the toaster will then dry out / reactivate the desiccant itself (but the desiccant is probably not actually helpful). If you are going to operate at 100C+, something as resilient as PC-CF is required at minimum, but I noted that PC-CF melted just a little at 120C.

The hygrometer versions work with cheap hygrometers from Amazon, like the JEDEW brand ones (https://amzn.to/3UXG0TV). Note that at high temperatures, their display will not work and the hygrometer may be damaged.

Can be printed with standard settings in most slicers with a 0.4mm nozzle, 0.2 layer height. Should also work fine with a 0.6mm nozzle. Turn on supports for the hygrometer boxes.