1 / 2
Voron Trident and v2 45deg angled PTFE inlet exhaust cover — zdjęcie 1
1 / 2

Voron Trident and v2 45deg angled PTFE inlet exhaust cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Exhaust cover for big Voron printers with PTFE inlet angled at 45'

Ocena
0 / 5
Polubienia
3
Pobrania
6
Wydruki
0
Wyświetlenia
50
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Monobody exhaust cover with 45' angled PTFE inlet, the rear clamp and entire idea of angled PTFE inlet is from Steve Peterson's original model.

Mirror the monobody in slicer if you'd like it to enter your printer from the other side.

BOM
- 3x heatsets m3x5x4
- 2x M5x10 bolts
- 1x M3 SHCS bolt for PTFE clamp, given how it is made with pass though hole the answer would be 'long enough, can be slightly longer'
- 2x M3 SHCS bolts to fasten the PTFE clamp to monobody

Printing
- Make sure first and every layer is of 0.2mm height. The hanging M5 holes have stepped bridges to support the round M5 overhang, any other layer height might result in slicer trying to print them mid layer with poor results.

AI disclaimer
This model was done entirely with LLM though harness hooked into Autodesk Fusion over its built in MCP API endpoint.

Tagi