13mm tube anti kink/collapse sleeve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This solid sleeve prints without supports and allows for tighter than normal bends with 10/13mm tubes without collapsing
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 62
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Printed without supports at 0.2mm layer height. I printed in PLA since my coolant never goes beyond 35c and these are not exactly structural parts. You can print in PETG if you want to be on the safe side.
Just a simple helper for really tight bends with regular soft tubing in a water cooled PC. The tubes can be freely pushed into the sleeve. PVC tubing might require some back and forth, or even lubricant but the mesh sleeving I used was really easy to push through

If using mesh tubing, make sure to not just cut the tube and mesh at the same length as the mesh will then roll up inside the tube. Roll the mesh/sleeving back a bit so you can cut about 1cm of tube off and then roll the mesh back out over the tubing and then tape it together so it does not roll back while being pushed into the sleeve.