1 / 3
13mm tube anti kink/collapse sleeve — image 1
1 / 3

13mm tube anti kink/collapse sleeve

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This solid sleeve prints without supports and allows for tighter than normal bends with 10/13mm tubes without collapsing

Rating
0 / 5
Likes
2
Downloads
4
Makes
0
Views
64
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

Printed without supports at 0.2mm layer height. I printed in PLA since my coolant never goes beyond 35c and these are not exactly structural parts. You can print in PETG if you want to be on the safe side.

Just a simple helper for really tight bends with regular soft tubing in a water cooled PC. The tubes can be freely pushed into the sleeve. PVC tubing might require some back and forth, or even lubricant but the mesh sleeving I used was really easy to push through

If using mesh tubing, make sure to not just cut the tube and mesh at the same length as the mesh will then roll up inside the tube. Roll the mesh/sleeving back a bit so you can cut about 1cm of tube off and then roll the mesh back out over the tubing and then tape it together so it does not roll back while being pushed into the sleeve.

Tags