Dumpling Maker / Press (w/ Fusion360 link)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple but rigid dumpling maker (or press) that I did for the dumpling wrappers that we are using at home…
- Ocena
- 4,75 / 5
- Polubienia
- 46
- Pobrania
- 445
- Wydruki
- 4
- Wyświetlenia
- 2335
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple but rigid dumpling maker (or press) that I did for the dumpling wrappers that we are using at home (~12cm diameter). I tried a lot of versions in thingiverse but they were difficult to be printed or too weak and break easily.
It's quite challenging to design it, it took some hours to do it the correct way. I think that for the average user is too difficult, so I have included below the link to the Fusion360 file so that you can download and edit it as you wish. Fusion360 link
NOTE: Two M5 bolts are needed, with a thread length of about 12mm, and you can add some superglue to hold it to the holes of the outer part.
There are 2 STL versions, the only difference is the outer diameter
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0.24mm
Infill:
25%
Filament: HatchBox PLA Grey
Notes:
It's a simple print. Takes a while.
Category: Kitchen & Dining