1 / 1
AMASS XT30 Strain-Relief Housing – Slim, for Ø3.4 mm Cable (20 AWG) — zdjęcie 1

AMASS XT30 Strain-Relief Housing – Slim, for Ø3.4 mm Cable (20 AWG)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This XT30 connector housing is designed for round cables with an outer diameter of Ø3.4 mm.

Ocena
5 / 5
Polubienia
435
Pobrania
735
Wydruki
2
Wyświetlenia
5198
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Most XT30 housings on Printables are designed for bulky RC/drone battery leads, typically using 14–16 AWG silicone wire for relatively high-current RC/drone applications. I needed a connector housing for a much thinner cable — an aquarium lighting cable with an outer diameter of Ø3.4 mm. I couldn’t find one, so I designed my own.

Hardware Requirements

  • 1× M2×8 mm pan-head or round-head screw (a button-head screw also works)

  • 1× M2 standard nut

Recommended Print Settings

  • Nozzle: 0.4 mm

  • Layer height: 0.20 mm (or 0.15 mm for slightly finer detail)

  • Supports: None required; print both halves flat on the bed

  • Infill: 100%, or use 4+ perimeters

Material Selection

Choose the filament according to the expected operating conditions:

  • PETG / ABS / ASA: Recommended for applications that may run warm, such as enclosed aquarium hoods, continuously operated lighting systems, or installations near power supplies.

  • PLA: Suitable for low-temperature applications where no significant local heat buildup is expected.