1 / 1
AMASS XT30 Strain-Relief Housing – Slim, for Ø3.4 mm Cable (20 AWG) — image 1

AMASS XT30 Strain-Relief Housing – Slim, for Ø3.4 mm Cable (20 AWG)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This XT30 connector housing is designed for round cables with an outer diameter of Ø3.4 mm.

Rating
5 / 5
Likes
438
Downloads
744
Makes
2
Views
5,228
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

Most XT30 housings on Printables are designed for bulky RC/drone battery leads, typically using 14–16 AWG silicone wire for relatively high-current RC/drone applications. I needed a connector housing for a much thinner cable — an aquarium lighting cable with an outer diameter of Ø3.4 mm. I couldn’t find one, so I designed my own.

Hardware Requirements

  • 1× M2×8 mm pan-head or round-head screw (a button-head screw also works)

  • 1× M2 standard nut

Recommended Print Settings

  • Nozzle: 0.4 mm

  • Layer height: 0.20 mm (or 0.15 mm for slightly finer detail)

  • Supports: None required; print both halves flat on the bed

  • Infill: 100%, or use 4+ perimeters

Material Selection

Choose the filament according to the expected operating conditions:

  • PETG / ABS / ASA: Recommended for applications that may run warm, such as enclosed aquarium hoods, continuously operated lighting systems, or installations near power supplies.

  • PLA: Suitable for low-temperature applications where no significant local heat buildup is expected.