3D Printed Patio Door Clamp / Outdoor Latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple, quick-to-use, and non-destructive outdoor door holder designed to keep your patio/balcony door temporarily…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A simple, quick-to-use, and non-destructive outdoor door holder designed to keep your patio/balcony door temporarily shut without getting locked outside. Perfect for stepping out to enjoy a coffee, hang laundry, or tend to your garden without worrying about the wind blowing the door open.
It works on the classic clothes-peg principle combined with an elastic cord: the cord provides constant tension, forcing the two printed halves to clamp securely onto the door frame.
🔑 Key Features
Non-Destructive: Uses friction and tension—no screws, adhesives, or permanent modifications required.
Wind-Resistant: Keeps the door tight against drafty gusts.
Ergonomic Design: Textures on the thumb grips ensure easy handling, even with wet hands or in cold weather.
Easy Assembly: Just thread an elastic cord or hair tie through the designated slot and knot it.
🖨 Print Settings
Parameter | Recommended Value |
|---|---|
Supports | No (Support-free design) |
Material | PETG or ASA/ABS recommended for outdoor UV and thermal resistance (PLA for testing) |
Layer Height |
|
Infill | 25% or higher (Gyroid, Grid, or Cubic) |
Walls / Perimeters | 3 to 4 for structural strength under tension |
Orientation | Print flat on the build plate (as designed) |
🛠 Assembly Instructions
Print both halves of the latch.
Take a strong elastic cord or hair tie.
Thread it through the central retention slot.
Tie a knot at the desired tension.
Place the clamp over your door frame gap and test the tension!