Subaru Forester SH 6.5 inch speaker adapters
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter rings to mount 6.5 inch speakers into factory locations
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Adapter rings for mounting 6.5 inch speakers into the factory locations.
Different adapters are required for the front and rear speakers due to the angled axis of the front speaker locations. The single front ring can be flipped in your slicer to produce left+right variants. The rear adapter is square to the axis and the mounting holes are symmetrical, so the model can be printed as-is for both sides.
Wires for the front speakers should be re-run through the door speaker cutout as there is no access through the surface side of the ring itself.
I recommend using speaker gasket on both the front and rear mounting surfaces. The rear speakers will require multiple layers of gasket in order to achieve a good seal to the door panel. Creating a matching profile from the model would be potentially possible (feel free to continue developing from the source files!). I have sound deadening installed, so using mine would not be an accurate measurement to represent the factory panel.
The models have orientation marks on the top-most screw hole to indicate up (as the factory mounts are not uniformly spread around the ring).
I printed with 5x walls and 5x top+bottom layers, with 15% infill. They are pretty solid.
Source files in onshape: