Beach Ring-Toss Lawn Game — Scoring Target Board + Tossing Rings (sand-resting, no stakes)

Beach Ring-Toss Lawn Game

A print-it-yourself ring-toss game for the beach, garden or campsite. No stakes, nothing to hammer in — the board just rests on the sand.

How to play: toss a ring underhand so it drops over one of the pins.

• Centre pin = 3 points

• 3 inner pins = 2 points each

• 5 outer pins = 1 point each

Print two boards and set them a few metres apart, or play to a target score solo. Print the rings in two filament colours for two teams (4 each).

What you print

• beach_washer_toss_target.stl — the scoring board: two decorative wave-engraved ring walls tied by a flat grate base (drains sand and water), with 9 scoring pins. Prints flat on the bed, no supports.

• beach_washer_toss_washers.stl — 8 tossing rings laid out flat (4 per team).

• beach_washer_toss_washer.stl — a single ring, if you'd rather print them one at a time.

Fully parametric — the included beach_washer_toss.scad exposes every size as a variable: board diameters (rim_od, cup_od), wall height, pin height/diameter, and the ring outer/inner diameter and thickness (washer_od, washer_id, washer_t). Scale the whole game up or down, or tune the ring-to-pin clearance for an easier/harder toss, then re-render.

Print in PLA for a quick game; PETG holds up better to sun, sand and saltwater.