Beach Tic-Tac-Toe in a Scallop-Shell Box — Sea-Creature Peg Game (starfish vs shells)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A pocket 3x3 peg tic-tac-toe for the beach that lives inside an openable scallop-shell clamshell box.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
Beach Tic-Tac-Toe in a Scallop-Shell Box
A pocket tic-tac-toe you can actually play on the beach, packed inside an openable scallop-shell box. The pieces are little starfish and scallop shells that plug into holes on the play field — a snug friction fit, so a gust of wind won't scatter them the way flat tokens blow away.
How it works
The lid is the play board — its inner face has the 3×3 field: 9 holes + an engraved # grid. Lift it off, turn it holes-up, and plug pieces in to play.
The base is a plain storage cup — no holes, so the loose pieces can't fall through or spill. Closed, the lid's holes face down into the cup and seal everything inside.
Starfish ×5 vs scallop shells ×5 — equal counts, so whoever starts, both players hold a full set (no swapping pieces around).
Pieces press in and pull out by hand, but stay put once placed. A thumb scoop at the wide edge pops the lid off.
What you print (all flat, no supports)
tictactoe_shells_base.stl— lower scallop valve = plain ribbed storage cup.tictactoe_shells_lid.stl— upper scallop valve = the play board (ribbed shell outside, 9 holes + # grid inside).tictactoe_shells_stars.stl— 5 starfish pegs.tictactoe_shells_shells.stl— 5 scallop-shell pegs.
Print the two peg sets in two filament colours so the players are obvious — and the base/lid in two colours for a two-tone shell.
Fully parametric — the included tictactoe_shells.scad exposes the shell size and rib count, the wall/floor, the hole pitch, the peg post/hole fit (post_d / hole_d) and the lid slip-fit (clr). Tighten or loosen the fit for your printer, or scale the whole thing up for bigger hands.
PLA is fine for a quick game; PETG holds up better to sun and saltwater.