[TPU] Gasket for Earcup Extension on Bose QuietComfort
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Additional gasket to improve snugness of fit to earcup extensions.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
After printing the original extension, I found the fit to be too loose. It could be snapped in, but would rattle around and did not provide an effective audio seal.
This gasket must be printed in TPU or some other flexible material. I have printed this with Shore 95A and works perfectly fine for my needs.
The gaskets are not perfectly symmetrical! The thicker face meant for the print bed should be against the spacer, and the thinner side/wedge towards the headphones.
Printed on a 0.4mm nozzle but I'm sure 0.6 would also work perfectly fine for this.
This is only the gasket! you still need the original model here: