VESA mounted monitor USB LED back light for AOC U27G4R or other 100x100 VESA
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A circular monitor back light that consists of an USB LED strip und is mounted on a 100x100 VESA
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Motivation
This is an addon I created primarily for my AOC U27G4R monitors. Having some light behind them feels much more comfortable especially when using the PC at night. I use a BONTEC triple monitor VESA mount and I liked the idea of simply adding a low profile light between the main mounting plate and the actual monitor. So, here is my outcome.
Printing recommendation
Black PETG (PLA may deform since the LED strips warms up a little bit)
2+ Walls
15 % infill
No supports
Concentric first and top layers for everything but the grommet (faster, since they are circular objects)
Smooth sheet for the spacer parts
Texture sheet for the lid and grommet
Additional hardware and electronics required
4x M4 screws (Length depends on the thickness of your mount)
With U27G4R spacer: 25 - 30 mm
Generic: 20 - 25 mm
50 cm USB LED strip with a width of 5 mm (I used these from AliExpress)
Assembly
With VESA mount
(Relevant AOC monitors only) Position the AOC spacer. The side with no gap must face upwards:

Postion the main part and the LED strip (The LED strip will be hold in place by the lid later on):

Add the lid and route the cable through the hole:

Add the grommet:

(Optional) Add plastic washers if your particular mounting plate collides with the grommet:

Add the mounting plate, some plastic washers and the screws and tighten them. Check for proper attachment of the LED strip when doing so. Move along the LED strip with you fingers and push it until it snaps:

Plug the USB cable into your power supply. I use the integrated USB ports and have configured them to be active only when the monitor is turned on. As you can see I've also added a 180 degree adapter and a manual switch for turning the light off when needed:

With VESA standing foot
Do the steps for VESA mount assembly in reverse :D Start from step 6.

See VESA mount assembly step 7
