Now Playing Vinyl Record Wall Mount Stand Hanger - Jwidess

This is a record/vinyl wall mount with "Now Playing" text. I designed this in two pieces specifically so the front "Now Playing" text would be printed face down on a textured build plate to give the best surface finish and appearance without requiring painting or post processing. Using a standard Textured PEI bed and Silk Gold PLA filament gave a beautiful surface finish I am very happy with! The mount is attached with two screws, 3.5mm or smaller in diameter.

Printing Notes:

In the photos above I have scaled up the model to 115% and I recommend doing so to improve print reliability as the individual letters are not connected until the end of the print and can easily detach from the bed and ruin the print. For this same reason I also recommend adding some paint on supports to the start of the letter overhangs (ref slicer image above) to prevent them from detaching from the bed mid print. Additionally, I highly recommend using a bed adhesive like glue stick, Magigoo, etc. To do my dual tone print, I added a pause command at layer 4 then swapped from my Silk Gold PLA to a black PLA+ filament for the rest of the print.

Once you have the two pieces printed, add some glue to the section that slots into the wall mount plate, then press them together. If the fit is too tight, try adjusting your X-Y compensation.

STEP and Fusion 360 Archive files can be found below for easy modification of the design.