Pixel Trim X-Connect Nut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replacement nut for X-Connect allows you to capture the connection in the pixel trim from yourpixelstore.com.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 13
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a replacement nut for X-Connect pixel connectors that allows you to capture the connection within the pixel trim from https://yourpixelstore.com/product/yps-pixel-mounting-trim-great-for-outlines/
Printed in PETG with .12 layer height. There are two versions. One accommodates a smaller diameter connector, the other is for larger diameter connectors. I have found the smaller diameter connector housings to be on the "Evo" style pixels I'm using where the larger diameter connector housing is found on typical "bullet" pixels. I think the larger will work for both though.
I use the 2.5inch Evo pixels and 2" spaced pixel trim. It's a tight fit even with the small form factor. Bullet pixels will not work with this unless perhaps you are using 3" spaced trim. I have not tried. Will not work on round cable. Made for "flat" cable and pigtails.
To install, simply cut off the original nut, slide the new nut over the end, slip the wire through the cutout in the snap ring. Snap the ring into the nut body. Screw together just like a normal connector. I use these between pixel trim pieces. It acts to align the two pieces and keeps everything tidy.