1 / 5
LGX LITE Dual filament switch case and Crossbow solution - LGX Lite Trifecta — zdjęcie 1
1 / 5

LGX LITE Dual filament switch case and Crossbow solution - LGX Lite Trifecta

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Inlet and outlet filament sensors with a novel double magnet pusher. Crossbow compatible.

Ocena
0 / 5
Polubienia
16
Pobrania
25
Wydruki
0
Wyświetlenia
604
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

NOTE: beware of the crossbow, it could ride up against the filament and make it seem like the extruder is not working correctly.   It needs a return spring to be reliable in my opinion. 

2026-09-27:  added a Duck Burner extruder adapter and a shorter strain relief for use without the crossbow.  Also added a maximum clearance version of the strain relief to get the full 120mm of Y travel on a  V0.  

This is a brand new case for your LGX Lite that adds an inlet and outlet filament sensor.  It has a unique round magnet switch that keeps it captive and slides on another magnet minimizing friction.

There are a few choices of middle frames, they carry the PTFE tube collets. 

1 - the original 4mml, just salvage the parts. Tested.
2 - the common 4mm collets that come with V6 hot ends.  (not uploaded yet)
3 - a large 6mm version for long twisty Bowden runs or hassle free TPU printing. Tested.  
     Collet found here:  https://www.aliexpress.us/item/3256807799280980

Microswitches:

2DF variety.  If you have the -L, or -R variants with levers or rollers, just rip them off. 

Neodymium Magnets:

2X:  3MM dia 2MM wide
2X:  6MM dia 3MM wide

Notes:
Print at .12 layer height.
Two of the parts have modeled in supports. Make sure you bring it into the slicer, turn auto drop off and then sort the parts. 

Drill out the filament hole to 2mm and make sure it is smooth.   
Drill out the shaft holes if they are small.  You will need a 3mm and a 4mm drill or slightly under.  Make sure there is no slop in this mechanism and that everything presses in.  It works perfectly as long as the shafts and tightening mechanism is drilled out to 3mm and 4mm.  



Tagi