Cinderella's Castle from Disney World
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a model of Cinderella's Castle from Disney World I made for a flight simulator a while back. Scaled to just…
- Ocena
- 4,9 / 5
- Polubienia
- 356
- Pobrania
- 2705
- Wydruki
- 15
- Wyświetlenia
- 13 366
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Architecture & Urbanism
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model of Cinderella's Castle from Disney World. This was originally made for the FlightGear open source flight simulator a while back. If you know where to find it and you try out FlightGear it should still be there. Scaled to just under 9 inches tall.
There are 3 versions in the files. One with the walk through tunnel, one with the tunnel closed up and one with a big cone on the bottom so it can used as a tree topper.
Made using AC3D.
Print Settings:
Suggest 3-5 walls and 15-30% infill. I like to use adaptive cubic infill or 2-3 gradual steps depending on the slicer.
Recommend no smaller than 50%. Printed one at 50% and one at 75% and it printed nicely at 75%. Slow it down a little in the slicer so it catches the detail. Took about 8 hours to print at 75% size at half speed.
Also, printed at 100 percent. 0.28 layers 30% cubic infill with 3 gradual steps, and 3 walls and it took 14 hours to print. This was a while back so with today's faster printers results should be better.