Cinderella's Castle from Disney World
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a model of Cinderella's Castle from Disney World I made for a flight simulator a while back. Scaled to just…
- Rating
- 4.9 / 5
- Likes
- 357
- Downloads
- 2,709
- Makes
- 15
- Views
- 13,392
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Architecture & Urbanism
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model of Cinderella's Castle from Disney World. This was originally made for the FlightGear open source flight simulator a while back. If you know where to find it and you try out FlightGear it should still be there. Scaled to just under 9 inches tall.
There are 3 versions in the files. One with the walk through tunnel, one with the tunnel closed up and one with a big cone on the bottom so it can used as a tree topper.
Made using AC3D.
Print Settings:
Suggest 3-5 walls and 15-30% infill. I like to use adaptive cubic infill or 2-3 gradual steps depending on the slicer.
Recommend no smaller than 50%. Printed one at 50% and one at 75% and it printed nicely at 75%. Slow it down a little in the slicer so it catches the detail. Took about 8 hours to print at 75% size at half speed.
Also, printed at 100 percent. 0.28 layers 30% cubic infill with 3 gradual steps, and 3 walls and it took 14 hours to print. This was a while back so with today's faster printers results should be better.