1 / 1
Science Olympiad Boomilever 2026-2027 Division C Jig — zdjęcie 1

Science Olympiad Boomilever 2026-2027 Division C Jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a jig for 2026-2027 Science Olympiad Boomilever event. This one jig would work for both bonus and non-bonus.

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
64
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution

Science Olympiad 2026-2027 Boomilever Division C Bonus and Non Bonus Jig

This is the Division C Boomilever building jig. The backplate includes 2 mounting holes which could be used for both Bonus design and Non Bonus Design with only one set of jigs. To build a Bonus (10 cm) boomilever, mount the bolt assembly on the lower hole. To build a Non Bonus (15 cm) boomilever, mount the bolt assembly on the upper hole. 

The hardware includes:

  • 1* Connector Bolt, 1/4-20 x 2.36 inches (60 mm) long, with a 0.66-inch (17 mm) diameter head and 0.78 inch (20 mm) unthreaded section

  • 2* Hex Nut, American National Standard, 1/4 — 20, 0.23-inch-thick maximum

  • 2* Flat Washer, USS 1/4 inch, approx. 3/4 inch outside diameter x 0.09-inch-thick maximum

Link to purchase these hardware

The jig includes: 

  • 1* Division C Assembly Jig

  • 1* Division C Large compression Jig

  • 1* Division C Small Compression Jig

Tagi