1 / 5
Grundfos Pump JB Cover — zdjęcie 1
1 / 5

Grundfos Pump JB Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Grundfos pump motor junction box cover. Old ones are brittle PPE and you can't find replacements for them. Viola.

Ocena
0 / 5
Polubienia
1
Pobrania
0
Wydruki
0
Wyświetlenia
15
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Public Domain

This pump was on a jacket water heater circulation pump. The cover cannot be bought separately, and they tend to be very brittle. This cover slides on nicely and has no distortion. The center screw hole aligns with the existing hole. 

I would print in either PETG or ASA, probably ASA/ABS if you have it available. 

You don't need supports, but with the radius, you might get some layer line distortion. You can either tune it out in the slicer with variable layer height, use supports, or just go with it. I just went with it since I wasn't going for perfection, and needed to mass produce these. 

Tagi