Airsoft Derringer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an airsoft deringer built around a green gas shotgun shell.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 240
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use 12ga or 20mm airsoft green gas shotgun shells with a side fill port. Look up PPS / SHS types. I purchased a set of 5 for about $50 to make a whole bandolier of 'black powder' airsoft deringers.
I made this file quite awhile ago for an event, and I figured that other folks may enjoy them!
Instructions:
Print one of each piece.
Remove support material, ensure that the inner section is free of any debris or rough spots.
Insert the firing pin with the rounded end facing into the hole, ensure the groove is aligned with the hole for the trigger.
Insert the narrow end of the trigger into the trigger well hole. It should slide into the groove of the firing pin.
Insert the trigger pin to hold the trigger and firing pin in place. Ensure that the trigger and firing pin move freely.
Place you gas shotgun cartridge into the cradle of the grip. Ensure the fill port is facing upwards.
Slide the rear band on first with the 'wings' facing the grip, then slide on the front band.
Enjoy!