Wide-Mouth Mason Jar Fermentation Lid with Weight Plunger (Airlock + Fridge Versions)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wide-mouth mason jar lid with a plunger that keeps your fermentation weight under the brine. Airlock + fridge versions.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
What it is
A one-piece, screw-on lid for wide-mouth (86 mm) mason jars. A hollow plunger reaches 2 in (50.8 mm) below the rim and presses on the outer edge of a standard 70 mm glass fermentation weight, so the weight can't float up and the ferment stays under the brine.
Fermenting lid: 1/2" hole for a standard rubber airlock grommet (3-piece or S-airlock). The hole is 20 mm off-center so the stem clears the weight's handle.
Fridge lid: the same lid with a solid top, for storing finished ferments under the brine.
Eight gas windows at the top of the plunger let CO2 from the headspace reach the airlock.
Seals with a standard wide-mouth silicone sealing ring (86 mm OD x 69 mm ID x about 3.4 mm thick), the kind sold for plastic mason jar storage caps. A TPU gasket STL of the same size is included if you'd rather print one.
Print the thread test ring first
Mason jar threads vary a little between brands. thread_test_ring_fitB is just the threaded part of the lid (about 2 h, 22 g). It should start easily, turn about 1.5-2 times and sit flat on the rim without wobbling. It was a perfect fit on my jars.
Print settings (PETG, 0.4 mm nozzle)
Print as oriented: lid top on the bed, plunger pointing up. No supports, no brim.
0.2 mm layers, 5 walls, 5 top and 5 bottom layers, 100% infill (gas-tight, and nothing for brine to soak into).
Thick bridges on; the window tops are short 6 mm bridges.
Moderate speeds help the threads come out accurately. I used 75 mm/s outer walls, 125 mm/s inner walls and 500 mm/s2 acceleration, with the part fan at 40-60%.
About 79 g and 4.5 hours per lid on an AnkerMake M5C.
Assembly and use
Push a rubber airlock grommet (for a 1/2" hole) into the hole and fit the airlock. Keep the stem less than about 30 mm below the lid.
Slide the silicone ring over the plunger tube and press it flat against the underside of the lid (groove toward the lid, if it has one).
Screw the lid on hand-tight. The plunger stops on the weight and holds it down.
Fridge lid: fermentation slows down in the fridge but doesn't stop completely, so burp the jar every week or so.
Food safety: use a food-contact PETG and hand-wash the lid. PETG softens around 75-80 °C, so keep it out of the dishwasher, and replace the lid if it gets deeply scratched or cloudy.
STEP files are included for remixing. Designed with AI assistance (Claude, using the build123d CAD library).
