QRP Antenna Balun with WAGO terminal
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified current balun box for wire antennas from OK1HRA.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 57
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a support-free remix of the original design by OK1HRA, published with his permission.
I redesigned the parts so they can be printed without supports. The small locating pin is now a separate part and slides into the TOP part using a snug friction fit. No glue is required.
I printed the complete model in PLA on a Prusa CORE One+ with:
0.4 mm nozzle
0.2 mm layer height
No supports
The small pin was printed upright, with its long axis vertical. It printed cleanly and fitted perfectly into the TOP part. Printing it horizontally might also work, but I have not tested that orientation. The finished print came out perfectly with these settings.