Sonicare HX6100 Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mount for Philips Sonicare HX6100 chargers that can be mounted with double-sided tape.
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 97
- Wydruki
- 2
- Wyświetlenia
- 1342
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix of thing:1118084 by Roy Edwards.
This is a wall mount for Philips Sonicare HX6100 chargers. It's intended to be mounted to a wall or tiles using double-sided tape such as 3M VHB and resembles a Feller light switch to blend in nicely.
Note that this is the EU charger version but a US charger probably fits too.
You can remix this using the STEP files in the downloads section or directly edit in Onshape CAD.
Additional Hardware
- 2 x M3 brass insert 5mm to 7mm long
- 2 x M3x10mm screw (8mm probbaly works too)
- Double-sided tape
Printing
It is recommended that you print with very high detail at 0.1mm layer height in order to get a smooth finish. Especially the the plate because it has a curve. You can use 0.2mm for the holder but 0.1mm obviously looks nicer.
Use 3 or more perimeters to support the screws and 10% or more infill. You can print this in what ever material you like. PLA is strong enough for this.
Post Processing & Assembly
- Clean out the holes of the holder with a 3mm drill bit.
- Expand the holes on the plate for your brass inserts if they don't fit. I used a 4.5mm drill bit.
- Insert the brass inserts using a soldering iron. Set the soldering iron temperature to approximately your printing temperature.
- Screw the holder on to the plate using the M3 screws.
- Apply double-sided tape to the back of the plate and mount it to the wall.
- Thread your charger's power cord through the holder from the top and seat the charger in the holder.
