1 / 2
Vacuum Sealer 8" bag holder — zdjęcie 1
1 / 2

Vacuum Sealer 8" bag holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Vacuum sealer bag holder for 8" bags. Working on an 11" bag file for the same base and a way to interchange.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
17
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Public Domain

I used two M3×8×5 heat inserts and a two M3x10mm button head screws. Below are the printer settings. for PETG. It can be used with a widemouth canning funnel. 

Setting

Value

Why

Nozzle/bed temp

~235°C / 80°C (start from your filament's spec)

Standard PETG range

Layer height

0.2mm

Good balance; drop to 0.16mm if you want the ring smoother where the bag drapes

Perimeters

3

Plate and posts are load-bearing; ring's 6mm tube radius has plenty of room for 3 walls

Top/bottom layers

5–6

Solid, stiff base plate

Infill

25–30%, gyroid or cubic

Structural infill for the plate/posts, not just cosmetic

Supports

On, "everywhere" (not build-plate-only)

The ring floats at Z=195mm — both the ~180° span between the two posts and the ~65° free tips at the open ends need support all the way up from the bed

Support type

Snug

Support overhang angle

~50°

Matches PETG's typical bridging tolerance

Orientation

As modeled — plate flat on bed, ring down. On base, small screw opening down. 

Don't let the slicer auto-rotate it

Speed

Moderate (40–50mm/s), slow the first layer

First layer sets your adhesion for a 201mm-tall print

Cooling

Increase fan specifically over the ring's support/bridge regions

PETG normally runs low cooling, but the overhangs need it

Tagi