1 / 2
Vacuum Sealer 8" bag holder — image 1
1 / 2

Vacuum Sealer 8" bag holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Vacuum sealer bag holder for 8" bags. Working on an 11" bag file for the same base and a way to interchange.

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
17
Reviews
0

Updated at source:

Model information

Category
Kitchen
License
Creative Commons — Public Domain

I used two M3×8×5 heat inserts and a two M3x10mm button head screws. Below are the printer settings. for PETG. It can be used with a widemouth canning funnel. 

Setting

Value

Why

Nozzle/bed temp

~235°C / 80°C (start from your filament's spec)

Standard PETG range

Layer height

0.2mm

Good balance; drop to 0.16mm if you want the ring smoother where the bag drapes

Perimeters

3

Plate and posts are load-bearing; ring's 6mm tube radius has plenty of room for 3 walls

Top/bottom layers

5–6

Solid, stiff base plate

Infill

25–30%, gyroid or cubic

Structural infill for the plate/posts, not just cosmetic

Supports

On, "everywhere" (not build-plate-only)

The ring floats at Z=195mm — both the ~180° span between the two posts and the ~65° free tips at the open ends need support all the way up from the bed

Support type

Snug

Support overhang angle

~50°

Matches PETG's typical bridging tolerance

Orientation

As modeled — plate flat on bed, ring down. On base, small screw opening down. 

Don't let the slicer auto-rotate it

Speed

Moderate (40–50mm/s), slow the first layer

First layer sets your adhesion for a 201mm-tall print

Cooling

Increase fan specifically over the ring's support/bridge regions

PETG normally runs low cooling, but the overhangs need it

Tags