Mercedes SLR320 convertible top compartment lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Repair for a mercedes slr320 convertible top compartment lid PETG or "better" since its used outdoors
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Repair i made for a colleages r320
Printed "upright" so the layer lines enclose the original metal shaft and there is no delamination - see screenshot of recommended orientation
you just need some kind of binder, i used 2-part composit glue for its strength
Steps:
prepare the broken part by filing down the old hookd and then cleaning the area of all the plastic dust
liberally apply glue to both the original car part as well as the 3d print
glue it together an apply some pressure
adjust the part so it fits perfectly
let it dry out to full hardness (my composit took around 24h)
if needed you can apply some glue to the edges to reinforce further
recommended print settings:
if possible without cooling for maximum strength
0,1mm layer hight
100% infill
support: required
Remixing/improvement welcome => fusion file attached