CANable V2 Adapter Case – Compact Snap-Fit Protective Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CANable V2 Adapter Case – Compact Snap-Fit Protective Case for Mobile / Workshop Use
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
CANable V2 Adapter Case – Compact Snap-Fit Protective Case for Mobile / Workshop Use
Introduction
A small, compact protective case for the CANable V2 USB-to-CAN adapter, designed for use as a mobile garage and workshop tool. The bare board is easy to damage, and exposed contacts can short out when it's thrown in a toolbag, left on a workbench or sitting on a bike or car while you're working. This case keeps it protected and insulated so it's ready to go wherever the diagnostics happen.
Unlike the other CANable cases available, which are intended for permanent DIN rail mounting, this one is made to be carried around and used on the move.
The case is two parts that snap securely together — no screws, no glue. There's a USB-C cutout at one end and a port for the three CAN wires at the other, so everything stays connected with the case closed. Print the top half in clear PETG and the adapter's status LEDs shine straight through, so you can still see what it's doing.
✅ Features
Small, compact, pocket- and toolbag-friendly case for the CANable V2
Protects the board from knocks and damage in a garage or workshop
Insulates the board to prevent accidental shorts
Two-part snap-fit design — secure, with no screws or glue
USB-C cutout at one end and a port for the three CANable wires at the other
Clear PETG top lets the status LEDs show through
No supports required
Original design
🖨 Recommended Print Settings
Setting | Value |
|---|---|
Material | Not critical — PETG recommended (clear PETG for the top half) |
Layer Height | 0.15 mm |
Nozzle | 0.4 mm |
Infill | Not critical |
Supports | Not required |
💡 Print the top half in clear PETG so the CANable's status LEDs are visible through the case. The bottom half can be any colour you like.
💡 Material and infill are not critical — adjust them to suit your printer, profile and what you have on hand.
🔧 Assembly
Print both halves — no supports needed (clear PETG recommended for the top).
Clean up any stringing or rough edges around the snap-fit features.
Connect USB-C at one end, run the three CAN wires through the port at the other, and check the status LEDs are visible through the top.
Seat the CANable V2 board into the bottom half.
Line up the top half and press together until the two parts snap securely closed.
Check the status LEDs are visible through the top.
🔌 Compatibility
CANable V2 USB-to-CAN adapter
⚠ Check the photos before printing. CANable V2 boards are made by several different sellers and some may vary slightly in board size, connector type or component placement. Compare your adapter against the photos to make sure it matches.
Using it on a bike, car or out in the shed? Post a make — I'd love to see it in action.