Clean Ball / Sphere (No Supports or Glue Required)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple clean ball with no messy over hangs and no glue required for assembly.
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 423
- Wydruki
- 1
- Wyświetlenia
- 1560
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple clean ball/sphere that's fun to print and assemble. No supports are required, and this print will assemble without using any adhesives or glue.
This ball has a diameter of 80mm. Each hemisphere is identical and symmetrical.
You can probably print the hemispheres with 15% or 20% infill, but for best results, print the center screw with 100% infill. Also a brim on the bottom of the screw seems to help create a cleaner print.
When assembling, be careful not to torque or over tighten the screw in the center. The screw will snap and break if you continue twist the two halves (remember that the screw piece is plastic and will break when too much force is applied).
The model in the photos were printed on my MK3S+ using the following materials/settings:
- Red/White Hatchbox ABS (stock Prusaslicer Settings)
- 0.4mm stock nozzle
- 0.2mm layer height (quality mode)
- 100% Infill (for hemispheres and screw)
- No supports
- Brim on pieces
- Textured PEI sheet
I am a 3D modeler, and this is my original creation! Please comment with your results and photos! If you feel there are any improvements that can be made, please let me know and maybe I can improve this model!