1 / 3
MKS3+ Dual Filament Guide — zdjęcie 1
1 / 3

MKS3+ Dual Filament Guide

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clip on dual filament clip for the MK3s+ and any other models that use the same injection molded filament holder.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
14
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I created a new model and used the base dimensions from JCOENG's design. I increased the thickness of the clip to reduce the chance it will break when being installed 2nd position up. I also reduce the height of the guide area, and sloped the transition to the clip for added strength. This means it uses less filament and prints a bit faster while still being stronger.

I printed in PETG, 0.2mm Layer Height, 30% standard Gyroid infill pattern in PrusaSlicer 2.9.6. Orient Flat side down, no supports needed.

It will fit on an MK3S+ and any other Prusa printers the use the same injected molded spool holder.

Tagi