1 / 2
Motorcycle Turn Signal Clamp for 33mm Forks — zdjęcie 1
1 / 2

Motorcycle Turn Signal Clamp for 33mm Forks

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 3D printed clamp for mounting turn signals to 33mm motorcycle forks.

Ocena
0 / 5
Polubienia
0
Pobrania
9
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Creative Commons — Attribution

I made this fork clamp because I needed a clean way to mount turn signals on my old KZ440 and couldn't find a good option. The available commercial parts were either inexpensive-looking universal clamps or more premium options that were hard to justify.

This design fits 33mm motorcycle forks and uses standard hardware:

  • 3D printed clamp body

  • M3 heat-set inserts required

  • M3 socket head cap screws required

Despite being printed in PLA, this part has held up surprisingly well after more than 2.5 years of installation. Your results may vary depending on climate, print settings, and exposure, but it has exceeded my expectations.

Print Notes:

  • Material: PLA tested

  • Heat-set inserts: M3 brass inserts

  • Hardware: M3 socket head cap screws

  • Orient/print settings may vary depending on your printer and material choice

Designed for personal use on my own motorcycle. Verify your fork diameter and hardware before printing.

Tagi