1 / 11
Magpul Hunter X-22 Stock Picatinny Light Rail — zdjęcie 1
1 / 11

Magpul Hunter X-22 Stock Picatinny Light Rail

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Picatinny rail for the Magpul Hunter X-22 Stock

Ocena
0 / 5
Polubienia
4
Pobrania
29
Wydruki
0
Wyświetlenia
263
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Model Description

I created this model to mount BRAUN Tactical Rail Mount LED Light to my Magpul X-22 Hunter Stock on my Ruger 10-22.

While I made this model specifically for mounting my BRAUN light, I suspect it will work with most pistol lights.

Required Hardware

This model mounts using [4] MLOK screws/nuts in the 2 forward-most MLOK slots on each side of the stock. (see pics)

Printing & Installation

I printed this using Prusament PC Blend, using PrusaSlicer's built-in profile, but changed it to 100% Infill, and supports enabled everywhere. My printer is a Prusa Core One with the HF0.4 nozzle.

This model will need to bend a fair amount to get it installed. I found Prusament PC Blend to be too inflexible to install under normal conditions. My solution was to heat the printed model in my oven, just below it's glass transition temp for about an hour, then install it while the model was hot. I'll likely have to break the mount if I ever uninstall it.

While iterating on the design, I printed most test prints using PETG and did not have the inflexibility issue. PETG would probably be fine for this, I'm new to using PC and wanted to test it out. 

Tagi