1 / 3
Print-in-Place Wyvern - Wings and Two Legs, Fits A1 mini — zdjęcie 1
1 / 3

Print-in-Place Wyvern - Wings and Two Legs, Fits A1 mini

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Articulated wyvern (16 vertebrae, wings, jaw, two legs) that prints in one piece, coiled to fit an A1 mini. No supports.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
10
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Articulated wyvern (16 vertebrae, wings, jaw, two legs) that prints in one piece, coiled to fit an A1 mini. No supports.

  • 16 hexagonal vertebrae with vertical pin hinges (0.4 mm clearance)

  • Wings print flat on the bed and lift 0–44°; opening jaw; one pair of legs, like a true wyvern

  • Printed coiled (14° per hinge): 157 × 160 mm at 100 %

  • Same family as the Mechanical Dragon, Baby Dragon and Sea Serpent

Print settings

A1 mini and any bed ≥ 170 mm: 100 %, 0.20 mm, PLA, no supports: about 1 h 42 min, 37 g (Bambu Studio project included). The roof of the mouth is the only overhang. After printing, flex each joint once starting from the tail.

About this design

Checked for overhangs and bed fit, and sliced in Bambu Studio before release. Pictures are 3D renders. Makes and feedback welcome.

Español

Wyvern articulado de 16 vértebras con alas, mandíbula y dos patas, de una pieza y sin soportes; cabe en el A1 mini al 100 % (157 × 160 mm): 1 h 42 min, 37 g.

العربية

وايفرن مفصل من 16 فقرة بجناحين وفك وساقين، يطبع قطعة واحدة بلا دعامات ويتسع على A1 mini.

Tagi