NOVELTY | Gum Dispenser – Basic Edition
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print-in-place flip-top sheath (single print) that snaps onto gum bottles. No assembly, reusable.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 237
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Standard Digital File License
A single print sheath with a hinged flip-top lid that gives ordinary chewing gum bottles a clean, minimalist look.
No assembly, screws, glue or tools required.
Please don't scale this model. The snap fit is tuned to the standardized bottle neck, so scaling will break the fit.
Looking for the chic version, then check here.
Have fun!
Compatibility
Tested with:
Airwaves, 46-piece bottle
Wrigley's Extra, same-size bottle
Orbit, same-size bottle
Print settings
Setting | Value |
|---|---|
Layer height | 0.15 mm |
Supports | Support on build plate only. |
Infill | 15 % |
Material | PLA, PLA+ |
Orientation | Upside down (rotated 180° from its position of use), lid open |
Installation
Remove the original lid from the gum bottle.
Slide the sheath over the bottle from above.
Press down until the sheath snaps into place.
Press the lid shut. A wedge-shaped lip on the inner rim of the lid grips the outer edge of the case and keeps the lid closed.
When the bottle is empty, pull the sheath off and snap it onto the next one.