Wall Saver for Baby Gate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Support-free baby gate wall protector with 25 mm inner and 35 mm outer diameters. Screw or tape in place.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 8
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Public Domain
This is a simple print that helps protect your walls from a baby gate’s feet. It’s a model with a 25 mm inner diameter and a 35 mm outer diameter, allowing it to fit both the exposed metal section and the rubber foot.
I created it after one of my baby gate’s rubber feet broke, leaving the metal portion protruding. The inner ring fits around the metal, while the outer ring accommodates the rubber foot.
The model prints without supports. You can either drill a pilot hole and drive a screw through it - the small center divot makes it easy to locate the center - or use double-sided tape on the back to secure it in place (which is what I did).