Glowing Crystal Earrings with CR2032 - Magnetic Case & Spiral Diffuser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Glowing crystal earrings: a magnetic two-part crystal hides a CR2032 and lights a 5 mm LED in a spiral diffuser.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 7
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A faceted crystal that glows: the two halves of the crystal hold together with small magnets and hide a CR2032 coin cell, and an ordinary 5 mm LED lights up a twisted pyramid diffuser hanging below. Printed in silk PLA, the crystal shines in daylight and glows in the dark.
How it works — no switch needed
The CR2032 sits inside the crystal; the LED legs go in and touch the battery. Bend the legs slightly so they press firmly against the cell.
An LED only lights one way round: insert it with the long leg (+) on the battery's + side and it glows.
To switch it off, take the LED out and insert it again with the legs swapped — it stays dark.
Magnets
Each half has a pocket for a Ø6 × 2.6 mm magnet; the magnets press the two halves together.
Check the polarity before gluing: the magnets in the two halves must attract each other.
Using Ø6 × 3 mm magnets? Make the magnet pockets deeper — the STEP files are included for that.
Parts to print (per earring)
Upper part, Lower part — the two halves of the crystal (24.5 × 24.5 × 17 mm each)
Spiral pyramid diffuser (14.5 × 14.5 × 14 mm) and Spiral pyramid diffuser lid (14 × 14 × 0.4 mm)
Bill of materials (per pair)
2× CR2032 coin cells
2× standard 5 mm LEDs
4× magnets Ø6 × 2.6 mm
2× gold earring hooks, 20 × 18 mm
Clear glue
Assembly
Glue the magnets into both halves — check that they attract.
Put the CR2032 into the crystal.
Glue the diffuser onto the LED with clear glue, then glue the diffuser lid on.
Bend the LED legs slightly and insert them so they touch the battery — flip the LED if it doesn't light.
Close the crystal — the magnets hold it together — and attach the earring hook.
Gift packaging
These earrings make a lovely gift — and they deserve a proper box. Mine are packed in a Twist Lock Present by 3D Printy — https://www.printables.com/model/89174-twist-lock-present — a printed gift box with a hidden latch that only opens when you twist the topper. Black with red ribbons, a big red bow on top and some shredded paper inside, it turns the earrings into a real present. The box is not part of this model — download it from 3D Printy's page.
Print settings
Printer: QIDI Q1 Pro, nozzle 0.2 mm, layer height 0.06 mm
Material: silk PLA (eSun eSilk-PLA Jacinth, red-orange)
Crystal halves: 4 walls, 0 % infill, supports on — about 45 min per pair
Diffuser and lid: 2 walls, 0 % infill, no supports — about 20 min per pair
