Shoehorn 170 mm (prints on edge)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shoehorn with a gentle R60 channel. Printed on its straight edge so layers run along its length and it does not snap.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 4
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Shoehorn with a gentle R60 channel. Printed on its straight edge so layers run along its length and it does not snap.
170 × 45 mm, 2.8 mm wall
Curve stays within 22° of vertical: no supports
Hanging hole
How it was checked
Checked with an overhang audit of the mesh and sliced in Bambu Studio: no supports needed.
Print settings
A1 mini, 0.20 mm, PLA, no supports: 31 min, 17 g.
Use a brim: it stands on a thin edge.
Parametric OpenSCAD source included: change the values at the top of the file.
About this design
Designed in code and checked before release (see above); sliced in Bambu Studio. Pictures are 3D renders, not photos. This is a new design: makes and feedback are very welcome.
Español
Calzador de 170 mm que se imprime de canto. Sin soportes: 31 min, 17 g.
العربية
ملعقة حذاء ١٧٠ مم.