1 / 2
3x21700, BE-220 GPS, Fast Charging Board IP2312 — zdjęcie 1
1 / 2

3x21700, BE-220 GPS, Fast Charging Board IP2312

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This modifies the large back/front allycat tdeck case to fit the components above. See images for build.

Ocena
0 / 5
Polubienia
0
Pobrania
4
Wydruki
0
Wyświetlenia
32
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Made in Tinkercad, it is a bit tough to get the fast charger in there, may need to file the edges a bit, but it can line up perfectly, and click into place. I use a spot welder to make battery packs with the 21700s. the combination makes a capable device with a good GPS module, 16800mAh battery, and the abilty to charge the large battery in a reasonable amount of time. It peaks at about 20W with the correct usbc power. Better than the 3W available on the tdeck port. I recommend printing these in glow in the dark or clear PETG. that way you can see the lights internal to the unit.

Links for parts

Fast Charging Board IP2312 CC/CV Mode 5V To 4.2V: https://www.aliexpress.us/item/3256812243627059.html

BE-220 GPS Module with Flash Navigation TTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller: https://www.amazon.com/dp/B0BV2MV2GN

9x9x5mm + 3M 8810 Thermal Conductive Adhesive Tape, mini Cooler Aluminum Heat Sink for Cooling: https://www.amazon.com/dp/B079FQ22LK