3x21700, BE-220 GPS, Fast Charging Board IP2312
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This modifies the large back/front allycat tdeck case to fit the components above. See images for build.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 32
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
Made in Tinkercad, it is a bit tough to get the fast charger in there, may need to file the edges a bit, but it can line up perfectly, and click into place. I use a spot welder to make battery packs with the 21700s. the combination makes a capable device with a good GPS module, 16800mAh battery, and the abilty to charge the large battery in a reasonable amount of time. It peaks at about 20W with the correct usbc power. Better than the 3W available on the tdeck port. I recommend printing these in glow in the dark or clear PETG. that way you can see the lights internal to the unit.
Links for parts
Fast Charging Board IP2312 CC/CV Mode 5V To 4.2V: https://www.aliexpress.us/item/3256812243627059.html
BE-220 GPS Module with Flash Navigation TTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller: https://www.amazon.com/dp/B0BV2MV2GN
9x9x5mm + 3M 8810 Thermal Conductive Adhesive Tape, mini Cooler Aluminum Heat Sink for Cooling: https://www.amazon.com/dp/B079FQ22LK
