DFRobot Beetle ESP32-C6 - ZigBee scene switch V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3x ZigBee button to which you can assign different tasks according to your code
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 10
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Public Domain
This is another case designed for the DFRobot Beetle ESP32-C6.
It is prepared for 12x12 7.5mm tact switches. If you prefer the button caps to be more protruding or the opposite, you can choose a different size instead of 7.5mm according to your preference. Since gluing the buttons caused various issues, I created a support piece on the back. If you apply glue to the protrusions where this piece fits into the main body and secure it in place, you won't experience any problems. Another advantage is that if you ever need to disassemble it, simply removing the support piece will suffice. Compared to the previous version, the back cover design has been changed and made sliding.
The Beetle has its own voltage divider, and if you select the LP (low power) GPIO pins for the three buttons, you won't need to use additional pull-up resistors for them either. This way, you can achieve a clean setup with only 4 wires: a common GND for the buttons and one wire from each of the three buttons.
Additionally, a 100 × 200 × 10 mm magnet has been placed inside the cover.